Basic inspection

DIAGNOSIS AND REPAIR WORK FLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION ABOUT SYMPTOM Get detailed information from the customer about the symptom (the condition and the env ...

B2614 ACC relay circuit

DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn the power supply position to ACC under the following conditions, and wait for 2 second or ...

Other materials:

Battery terminal with fusible link
Exploded View 1 : Battery terminal with fusible link 2 : Harness connector : N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Disconnect the battery cable from the negative terminal. 2. Remove cover of battery positive terminal. 3. Remove harness mounting nut and battery terminal with ...

Blower motor
Exploded View 2WD models 1. A/C unit assembly 2. Fan control amp.*1 3. Blower fan resistor*2 4. Blower motor 5. Blower motor cover • *1: Automatic air conditioner • *2: Manual air conditioner or Manual heater 4WD models 1. A/C unit assembly 2. Blower fan resistor*1 3. Sub harnes ...

B1202, B1203, B1204, B1205, B1206, B1207 diagnosis sensor unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...