Wheelarch Height

2WD Measure value under unladen* conditions. *: Fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions. 4WD Measure value un ...

Precaution

Precautions for Suspension • When installing rubber bushings, the final tightening must be carried out under unladen conditions with tires on ground. Spilled oil might shorten the life of rubber b ...

Other materials:

P1225 TP sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

Push-button ignition switch operation
When the ignition switch is pushed without depressing the brake pedal (Continuously Variable Transmission models) or the clutch pedal (manual transmission models), the ignition switch position will change as follows: • Push once to change to ACC. • Push two times to change to ON. • Push thre ...

Component parts
Starting system (with intelligent key) : Component Parts Location 1. IPDM E/R Refer to PCS-5, "Component Parts Location". 2. Transmission range switch (CVT models) Refer to TM-131, "CVT CONTROL SYSTEM : Component Parts Location" (MR16DDT), TM-314, "CVT CONTROL SYS ...