Nissan Juke Service and Repair Manual : Service data and specifications (SDS)
Rear suspension beam
Exploded View
1. Rear suspension beam
2. Rear suspension arm bracket
: Always replace after every
disassembly.
: N·m (kg-m, ft-lb)
Removal and Installation
REMOVAL
1. Remove tires. Refer ...
Wheel Alignment
HR16DE, K9K
Measure value under unladen*2 conditions.
*1: Since adjustment mechanism is not included, the value of the left and right
wheels (both wheels) must be
used as the standard value.
...
Other materials:
Exterior rear
1. Lift gate
— Intelligent Key system
2. Rear window wiper and washer
— Switch operation
— Window washer fluid
3. Rear spoiler
4. High-mounted stop light
5. Antenna
— Satellite radio antenna
6. Rear window defroster
7. Fuel-filler door
— Operation
— Fuel recommend ...
B1177 lap Pre-tensioner RH
DTC Logic
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSTIC RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp status. Refe ...
Unit removal and installation
Transaxle assembly
Exploded View
1. Transaxle assembly
: Refer to "INSTALLATION" in
TM-30, "Removal and Installation" for the locations and tightening torque.
Removal and Installation
CAUTION:
Never reuse CSC (Concentric Slave Cylinder). Because CSC slides back to the
...
