Nissan Juke Service and Repair Manual : Periodic maintenance

Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applicable ...

Rear suspension assembly
Inspection COMPONENT PART Check the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal. SHOCK ABSORBER ASSEMBLY Check for oil leaka ...

Other materials:

P0139 HO2S2
DTC Logic DTC DETECTION LOGIC The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst 1 causes the longer switching time. To judge the malfunctions of heated oxygen sensor 2, ...

B2622 inside antenna
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “INSIDE ANT DIAGNOSIS” in “WORK SUPPORT” mode. 3. Perform inside key antenna (“INSIDE ANT DIAGNOSIS”) on “WORK ...

Diagnosis and repair workflow
Work Flow INTRODUCTION The TCM receives a signal from the vehicle speed sensor, transmission range switch and provides shift control or lock-up control via CVT solenoid valves. The TCM also communicates with the ECM by means of a signal sent from sensing elements used with the OBD-related p ...