Nissan Juke Service and Repair Manual : Rear suspension assembly

Inspection

COMPONENT PART

Check the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal.

SHOCK ABSORBER ASSEMBLY

Check for oil leakage, damage, and replace if necessary.

    Wheel alignment
    Inspection DESCRIPTION Measure wheel alignment under unladen conditions. NOTE: “Unladen conditions” means that fuel, engine coolant, and lubricant are full. Spare tire, jack, hand tools an ...

    Other materials:

    C1140 actuator relay system
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CON ...

    Diagnosis system (EPS control unit)
    Consult-III Function FUNCTION CONSULT-III can display each diagnostic item using the diagnostic test modes shown following. *: The following diagnosis information is erased by erasing. • DTC • Freeze frame data (FFD) ECU IDENTIFICATION Displays the part number stored in the control un ...

    B2626 OUTSIDE ANTENNA
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Disconnect outside key antenna (driver side) connector. 2. Perform “INTELLIGENT KEY” Self Diagnostic Result. Is outside key antenna DTC detected? YES >> Refer to DLK-236, "Diagn ...