Service data and specifications (SDS)

Wheel Bearing ...

Precaution

Precautions for Drive Shaft • Observe the following precautions when disassembling and assembling drive shaft. - Never disassemble joint sub-assembly because it is non-overhaul parts. - Perform ...

Other materials:

Readiness for Inspection/Maintenance (I/M) test
WARNING A vehicle equipped with All-Wheel Drive (AWD) should never be tested using a two wheel dynamometer (such as the dynamometers used by some states for emissions testing), or similar equipment. Make sure you inform test facility personnel that your vehicle is equipped with AWD before it ...

Key ID warning does not operate
Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index&qu ...

Brake and clutch (if so equipped) fluid
For additional brake and clutch fluid information, see “Capacities and recommended fuel/lubricants”  of this manual. WARNING • Use only new fluid from a sealed container. Old, inferior or contaminated fluid may damage the brake and clutch systems. The use of improper fluids can damage t ...