Nissan Juke Service and Repair Manual : Rear drive shaft

Inspection

• Check drive shaft mounting point and joint for looseness and other damage.

• Check boot for cracks and other damage.

CAUTION:
Replace entire drive shaft assembly when noise or vibration occur from drive shaft.

    Rear wheel hub and housing
    Inspection COMPONENT PART Check the mounting conditions (looseness, back lash) of each component and component conditions (wear, damage) are normal. WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE ...

    Other materials:

    Input shaft and gear
    Exploded View 1. Input shaft front bearing 2. Input shaft 3. 3rd input gear 4. Spacer 5. Snap ring 6. 3rd baulk ring 7. 3rd-4th coupling sleeve 8. 3rd-4th synchronizer hub 9. Insert key 10. 4th baulk ring 11. 4th input gear 12. 5th input gear 13. 5th baulk ring 14. 5th-6th c ...

    Symptom diagnosis
    Noise, vibration and harshness (NVH) Troubleshooting NVH troubleshooting Chart 1. Locate the area where noise occurs. 2. Confirm the type of noise. 3. Specify the operating condition of engine. 4. Check specified noise source. If necessary, repair or replace these parts. A: Closely rel ...

    Precaution
    NOTE: If any malfunction occurs in the RE0F10A model transaxle, replace the entire transaxle assembly. • Before connecting or disconnecting the TCM harness connector, turn ignition switch OFF and disconnect negative battery cable. Because battery voltage is applied to TCM even if ignition s ...