Nissan Juke Service and Repair Manual : Rear wheel hub and housing

Inspection

COMPONENT PART

Check the mounting conditions (looseness, back lash) of each component and component conditions (wear, damage) are normal.

WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE)

Check the following items, and replace the part it necessary.

• Move wheel hub assembly in the axial direction by hand. Check there is no looseness of wheel bearing.

Axial end play : Refer to RAX-24, "Wheel Bearing".

• Rotate wheel hub assembly and check there is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub assembly.

    Rear drive shaft
    Inspection • Check drive shaft mounting point and joint for looseness and other damage. • Check boot for cracks and other damage. CAUTION: Replace entire drive shaft assembly when noise or ...

    Other materials:

    P0603 ECM
    Description ECM has the memory function of the DTC memory, the air-fuel ratio feedback compensation value memory, the Idle Air Volume Learning value memory, etc. even when the ignition switch is turned OFF. DTC Logic DTC DETECTION LOGIC *: This self-diagnosis is not for ECM power supply ci ...

    A/C auto AMP.
    Reference Value CONSULT-III DATA MONITOR REFERENCE VALUES *: “DUTY” is displayed, but voltage is indicated. Or unit is not displayed but unit is (V). TERMINAL LAYOUT PHYSICAL VALUES *: With K9K Fail-safe FAIL-SAFE FUNCTION If a communication error exists between the A/C auto am ...

    Front power window switch (passenger side)
    Component Function Check 1. CHECK FRONT POWER WINDOW SWITCH (PASSENGER SIDE) FUNCTION Check front power window motor (passenger side) operation with front power window switch (passenger side). Is the inspection result normal? YES >> INSPECTION END NO >> Refer to PWC-22, "Di ...