Nissan Juke Service and Repair Manual : Service data and specifications (SDS)

Nissan Juke Service and Repair Manual / Rear Axle 4WD / Service data and specifications (SDS)

Wheel Bearing

Drive Shaft


Drive Shaft

*: For measuring position, refer to RAX-21, "FINAL DRIVE SIDE : Disassembly


*: For measuring position, refer to RAX-21, "FINAL DRIVE SIDE : Disassembly and Assembly".

    Rear drive shaft
    Exploded View 1. Circular clip 2. Dust shield 3. Housing 4. Snap ring 5. Ball cage/steel ball/inner race assembly 6. Stopper ring 7. Boot band 8. Boot 9. Shaft 10. Joint sub-assembly ...

    Other materials:

    A/C auto AMP. Connection recognition signal circuit
    Diagnosis Procedure 1.CHECK A/C AUTO AMP. CONNECTION RECOGNITION SIGNAL 1. Turn ignition switch ON. 2. Check voltage between combination meter harness connector and ground. Is the inspection result normal? YES >> INSPECTION END NO >> GO TO 2. 2.CHECK A/C AUTO AMP. CONNECTION R ...

    Sample/Wiring Diagram -Example-
    Each section includes wiring diagrams. Description SWITCH POSITIONS Switches are shown in wiring diagrams as if the vehicle is in the “normal” condition. A vehicle is in the “normal” condition when: • ignition switch is “OFF”, • doors, hood and trunk lid/back door are ...

    Additional service when replacing TCM
    Description Always perform the following items when the TCM is replaced. CHECK LOADING OF CALIBRATION DATA • The TCM acquires calibration data (individual characteristic value) of each solenoid that is stored in the ROM assembly (in the control valve). This enables the TCM to perform accur ...