Nissan Juke Service and Repair Manual : Precaution

Precautions for Drive Shaft

• Observe the following precautions when disassembling and assembling drive shaft.

- Never disassemble joint sub-assembly because it is non-overhaul parts.

- Perform work in a location which is as dust-free as possible.

- Clean the parts, before disassembling and assembling.

- Prevent the entry of foreign objects during disassembly of the service location.

- Reassemble disassembled parts carefully in the correct order. If work is interrupted, a clean cover must be placed over parts.

- Use paper waste. Fabric shop cloths must not be used because of the danger of lint adhering to parts.

- Clean disassembled parts (except for rubber parts) with kerosene which shall be removed by blowing with air or wiping with paper waste.

    Other materials:

    Key out interlock door unlock function does not operate
    Diagnosis Procedure 1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT” mode. 3. Check “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT”. Re ...

    U1000 can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern vehicle is equipped with many electronic control unit, and eac ...

    PTC heater
    Component Function Check 1.CHECK PTC HEATER OPERATION 1. Start the engine. 2. Operate fan control dial. 3. Operate temperature control dial to full hot position. 4. Check for warm air at discharge air outlet. NOTE: • Engine must be cold. • Battery must be charged. Is the inspection re ...