Service data and specifications (SDS)

Precaution

Other materials:

P0745 pressure control solenoid A
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repair, perform the following procedure to confirm the mal ...

Front suspension assembly
Inspection COMPONENT PART Check the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal. BALL JOINT AXIAL END PLAY 1. Set front wheels in a straight-ahead position. 2. Measure axial end play by prying it up/down with iron bar or eq ...

Transaxle assembly
Exploded View CASE AND HOUSING 1. Filler plug 2. Gasket 3. Transaxle case 4. Bushing 5. Snap ring 6. Oil channel 7. Oil gutter 8. Position switch 9. Bracket 10. Differential side oil seal 11. Magnet 12. Drain plug 13. Input shaft oil seal 14. Clutch housing 15. 2 way conn ...