Nissan Juke Service and Repair Manual : BCM (body control module)

Removal and Installation

CAUTION:
Before replacing BCM, perform “READ CONFIGURATION” to save or print current vehicle specification.

Refer to BCS-150, "Description".

REMOVAL (RHD MODELS)

1. Remove glove box assembly. Refer to IP-13, "Removal and Installation".

2. Remove harness clip.

3. Remove BCM mounting screws.

4. Remove BCM and disconnect the connectors.

5. Remove relays and relay mounting bracket from BCM.

REMOVAL (LHD MODELS)

1. Remove instrument lower panel. Refer to IP-13, "Removal and Installation".

2. Remove harness clip.

3. Remove BCM mounting screws.

4. Remove BCM and disconnect the connectors.

5. Remove relays and relay mounting bracket from BCM.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
• Be sure to perform “WRITE CONFIGURATION” when replacing BCM.

• Be sure to perform the system initialization (NATS) when replacing BCM. Refer to BCS-151, "Work Procedure".

    Combination switch
    Exploded View 1. Combination switch 2. Combination switch connector Removal and Installation REMOVAL 1. Remove steering column cover. Refer to IP-13, "Removal and Installation". 2 ...

    Other materials:

    P0335 CKP sensor (POS)
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or ...

    Idle air volume learning
    Description Idle Air Volume Learning is a function of ECM to learn the idle air volume that keeps each engine idle speed within the specific range. It must be performed under any of the following conditions: • Each time electric throttle control actuator or ECM is replaced. • Idle speed ...

    System setting
    Temperature Setting Trimmer DESCRIPTION If the temperature felt by the customer is different from the air flow temperature controlled by the temperature setting, the A/C auto amp. control temperature can be adjusted to compensate for the temperature setting. HOW TO SET With CONSULT-III P ...