Additional service when removing battery negative terminal

Description • The NAVI control unit is equipped with the anti-theft system. • The NAVI control unit operates after authenticating a fixed four-digit anti-theft code. • After removing the battery ...

Power supply and ground circuit

Navi control unit NAVI CONTROL UNIT : Diagnosis Procedure 1.CHECK FUSE Check for blown fuses. Is inspection result OK? YES >> GO TO 2. NO >> Be sure to eliminate cause of malfunc ...

Other materials:

Hood switch
Component Function Check 1.CHECK FUNCTION 1. Select “HOOD SW” in “Data Monitor” mode of “IPDM E/R” using CONSULT-III. 2. Check “HOOD SW” indication under the following condition. Is the indication normal? YES >> Hood switch is OK. NO >> Go to SEC-155, "Diagnosis Procedure& ...

B1138, B1139, B1140, B1141, B1142, B1143 diagnosis sensor unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

Diagnosis system (IPDM E/R)
Diagnosis Description AUTO ACTIVE TEST Description In auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their operation. • Oil pressure warning lamp (only for K9K engine models) • Rear window defogger • Front wiper motor • Parking lamp • License p ...