Inspection

INSPECTION AFTER INSTALLATION • Check accelerator pedal moves smoothly within the whole operation range when it is fully depressed and released. • Check accelerator pedal securely returns to ...

Precaution

...

Other materials:

P0102, P0103 MAF SENSOR
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. Which DTC is detected? P0102 >> GO TO 2. P0103 & ...

System
System Description SYSTEM DIAGRAM • The multi display unit transmits the operation status of the drive mode switch to other units via CAN communication as the mode signal (refer below). - NORMAL: ON/OFF - SPORT: ON/OFF - ECO: ON/OFF • Based on the mode signals received from TCM (CVT ...

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...