Precaution Necessary for Steering Wheel Rotation after Battery Disconnect

NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all co ...

Service Notice or Precautions for Clut

WARNING: After cleaning clutch disc, wipe it with a dust collector. Never use compressed air. CAUTION: • Clutch fluid use refer to MA-13, "Fluids and Lubricants". • Never reuse d ...

Other materials:

Locking with key
The power door lock system allows you to lock or unlock all doors simultaneously. •  Turning the driver’s door key cylinder to the front of the vehicle1 will lock all doors and the lift gate. • Turning the driver’s door key cylinder once to the rear of the vehicle2 will unlock t ...

P1643 thermoplunger control unit
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK THERMOPLUNGER CONTROL UNIT POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect thermoplunger control unit harness connector. 3. Check the voltage between thermoplunger control unit harness connector and ground. Is the ...

B2620 Park/neutral position switch
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON and wait 2 seconds or more under the following conditions. 2. Set shift lever in the Neutral position and wait for 2 seconds or more. 3. Set shift lever in the Reverse p ...