Nissan Juke Service and Repair Manual : Periodic maintenance

Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If necessary, ...

Clutch pedal
Inspection and Adjustment INSPECTION The Height of Clutch Pedal 1. Turn the floor carpet. 2. Check that the clutch pedal height “H1” from the dash lower panel (1) is within the reference value. ...

Other materials:

P1650 starter motor relay 2
Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. Models with no Intelligent Key System transmit a control signal directly to IPDM E/R. On the other hand, models with the Intelligent Key System transmit a control signal to IPDM E/R by w ...

Periodic maintenance
REAR WHEEL HUB Inspection COMPONENT PART Check the mounting conditions (looseness, back lash) of each component and component conditions (wear, damage) are normal. WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE) Check the following items, and replace the part it necessary. • Move wheel hub ...

B26F5 steering lock status switch
DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26F5 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B26F5 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, "D ...