Nissan Juke Service and Repair Manual : Basic inspection
- Diagnosis and repair workflow
- Additional service when replacing TCM
- Additional service when replacing transaxle assembly
- Calibration of decel G sensor
- Idle neutral control learning
- CVT fluid
- Stall test
- Line pressure test
- Road test
- CVT position
CVT shift lock system
Wiring diagram
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if
notdescribed
in wiring diagram), refer to GI-12, "Connector Information/Expla ...
Diagnosis and repair workflow
Work Flow
INTRODUCTION
The TCM receives a signal from the vehicle speed sensor, transmission range
switch and provides shift control
or lock-up control via CVT solenoid valves.
The TCM also co ...
Other materials:
Wiring diagram
AUTOMATIC AIR CONDITIONING SYSTEM
Wiring Diagram
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation
of Option Abbreviation".
...
Periodic maintenance
REAR PROPELLER SHAFT
Inspection
APPEARANCE AND NOISE
• Check the propeller shaft tube surface for dents or cracks. If damaged,
replace propeller shaft assembly.
• If center bearing is noisy or damaged, replace propeller shaft assembly.
VIBRATION
If vibration is present at high speed, i ...
Hood
Exploded View
1. Hood assembly
2. Hood bumper rubber
3. Radiator core seal
4. Hood bumper rubber
5. Clamp
6. Hood hinge
7. Grommet
8. Hood support rod
: Clip
: Pawl
: Body grease
Hood assembly
HOOD ASSEMBLY : Removal and Installation
CAUTION:
• Operate with two workers, becau ...
