Nissan Juke Service and Repair Manual : Calibration of decel G sensor

Description

TCM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the following work is performed.

• Removal/installation or replacement of G sensor • Replacement of TCM

Procedure

1.PREPARATION BEFORE CALIBRATION PROCEDURE

1. Park the vehicle on a level surface.

2. Adjust air pressure of all tires to the specified pressure. WT-9, "Road Wheel".

>> GO TO 2.

2.PERFORM CALIBRATION

1. Turn ignition switch ON.With CONSULT-III


1. Turn ignition switch ON.

CAUTION:
Never start engine

.

2. Select “Work Support” in “TRANSMISSION”.

3. Select “G SENSOR CALIBRATION”.

4. Touch “Start”.

CAUTION:
Never swing the vehicle during “G sensor calibration”.

Is “COMPLETED” displayed? YES >> GO TO 3.

NO >> Perform steps 1 and 2 again.

3.PERFORM THE SELF-DIAGNOSIS

1. Turn ignition switch OFF and wait for 10 seconds.With CONSULT-III


1. Turn ignition switch OFF and wait for 10 seconds.

2. Turn ignition switch ON.

3. Select “Self Diagnostic Results” in “TRANSMISSION”.

Is “P1585” detected? YES >> Go to TM-236, "DTC Logic".

NO >> Calibration end

    Additional service when replacing transaxle assembly
    Description Perform the following work after the transaxle assembly is replaced. CHECK LOADING OF CALIBRATION DATA • The TCM acquires calibration data (individual characteristic value) of each ...

    Idle neutral control learning
    Description TCM corrects an individual difference in clutch clearance of the transaxle assembly by performing the idle neutral control learning and enables accurate idle neutral control. Theref ...

    Other materials:

    Wiring diagram
    DOOR & LOCK SYSTEM Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". ...

    Power supply and ground circuit
    Diagnosis Procedure 1.CHECK 4WD CONTROL MODULE POWER SUPPLY (1) 1. Turn the ignition switch OFF. 2. Disconnect 4WD control module harness connector. 3. Check the voltage between 4WD control module harness connector and ground. 4. Turn the ignition switch ON. CAUTION: Never start the engin ...

    Units
    • The UNITS given in this manual are primarily expressed as the SI UNIT (International System of Unit), and alternatively expressed in the metric system and in the yard/pound system. Also with regard to tightening torque of bolts and nuts, there are descriptions both about range and about ...