Radiator : Inspection

Check radiator for mud or clogging. If necessary, clean radiator as follows. CAUTION: • Be careful not to bend or damage radiator fins. • When radiator is cleaned without removal, remove all surr ...

Radiator

Exploded View 1. Reservoir tank hose 2. Mounting rubber (upper) 3. Radiator tank cap 4. Radiator 5. Mounting rubber (lower) 6. O-ring 7. Drain plug 8. Clamp 9. Radiator hose (lower) ...

Other materials:

Rear suspension assembly
Exploded View 1. Rear suspension member 2. Rebound stopper 3. Washer : Vehicle front N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Remove tires. Refer to WT-7, "Removal and Installation". 2. Remove center pipe. Refer to EX-6, "Removal and Installation". 3. ...

Security indicator lamp
Component Function Check 1.CHECK FUNCTION 1. Perform “THEFT IND” in “ACTIVE TEST” mode of “IMMU” of “BCM” using CONSULT-III. 2. Check security indicator lamp operation. Is the inspection result normal? YES >> INSPECTION END NO >> Go to SEC-159, "Diagnosis Procedure". ...

P181D engine torque signal
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...