Removal and installation

Exhaust system Exploded View 2WD 1. Center muffler 2. Mounting rubber 3. Spring 4. Seal bearing 5. Stud bolt 6. Three way catalyst 7. Heated oxygen sensor 2 8. Seal bearing 9. Ring ...

Precaution

...

Other materials:

Removal and Installation Procedure for CVT Unit Connector
REMOVAL • Rotate bayonet ring (A) counterclockwise. Pull out CVT unit harness connector (B) upward and remove it. INSTALLATION 1. Align marking (A) on CVT unit harness connector terminal with marking (B) on bayonet ring. Insert CVT unit harness connector. 2. Rotate bayonet ring clockwise. ...

P0335 CKP sensor (POS)
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. TESTING CONDITION: Before performing the following proced ...

Forward-facing child restraint installation using the seat belts
WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to a child in a sudden ...