Nissan Juke Service and Repair Manual : Removal and Installation

CAUTION

:
• Be sure to use genuine exhaust system parts or equivalents which are specially designed for heat resistance, corrosion resistance, and shape.

• Perform the operation with the exhaust system fully cooled down because the system will be hot just after engine stops.

• Be careful not to cut your hand on the heat insulator edge.

    Other materials:

    P0488 EGR system
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK EGR VOLUME CONTROL VALVE CONTROL CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect EGR volume control valve harness connector and ECM harness connector. 3. Check the continuity between EGR volume control valve terminal harness co ...

    Unit removal and installation
    Transaxle assembly Exploded View 1. CVT fluid level gauge 2. CVT fluid charging pipe 3. O-ring 4. Transaxle assembly 5. Air breather hose A. For tightening torque, refer to TM-301, "Removal and Installation". Removal and Intallation REMOVAL WARNING: Never remove the reservo ...

    Diagnosis system (BCM) (with intelligent key system)
    Common item COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the ...