Periodic maintenance

EXHAUST SYSTEM Inspection Check exhaust pipes, muffler, and mounting for improper attachment, leakage, cracks, damage or deterioration. • If anything is found, repair or replace damaged parts. ...

Exploded View

1. Mounting rubber 2. Main muffler 3. Seal bearing 4. Spring 5. Mounting rubber 6. Seal bearing 7. Exhaust front tube 8. Heated oxygen sensor 2 9. Sub muffler 10. Gasket : Always rep ...

Other materials:

Engine maintenance (HR16DE)
Drive belt DRIVE BELT : Checking • Inspection should be done only when engine is cold or over 30 minutes after the engine is stopped. 1 : Alternator 2 : Water pump 3 : Crankshaft pulley 4 : A/C compressor 5 : Idler pulley 6 : Drive belt • Visually check belts for wear, damage, and cr ...

Service data and specifications (SDS)
General Specifications MR16DDT HR16DE, K9K Brake Pedal Brake Booster 2WD 4WD Front Disc Brake MR16DDT HR16DE, K9K Rear Disc Brake ...

P0740 torque converter
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1.PREPARATION BEFORE OPERATION (PART 1) If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next ...