Nissan Juke Service and Repair Manual : Inspection

INSPECTION AFTER INSTALLATION

• Check clearance between tail tube and rear bumper is even.

• With engine running, check exhaust tube joints for gas leakage and unusual noises.

• Check to ensure that mounting brackets and mounting rubbers are installed properly and free from undue stress. Improper installation could result in excessive noise and vibration.

    Removal and Installation
    REMOVAL • Disconnect each joint and mounting. • Remove heated oxygen sensor 2 with following procedure: - Using heated oxygen sensor wrench [SST: KV10114400] (A), removal heated oxygen sensor ...

    Other materials:

    LAN System can system (type 5)
    DTC/CIRCUIT DIAGNOSIS Main line between IPDM-E and DLC circuit Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (connector s ...

    Door lock status indicator does not illuminate
    Diagnosis Procedure 1.CHECK DOOR LOCK STATUS INDICATOR Check door lock status indicator. Refer to DLK-395, "Component Function Check". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace the malfunctioning parts. 2.CONFIRM THE OPERATION Conf ...

    NissanConnect Manual
    Please refer to the digital NissanConnect manual by scanning the integrated QR code printed on this page with your smartphone, or consult your physical, printed NissanConnect manual textbook (if so equipped with your vehicle trim). This specialized supplementary documentation i ...