Removal and installation

MULTI DISPLAY UNIT Exploded View REMOVAL Refer to IP-12, "Exploded View". DISASSEMBLY 1. Silencer tape 2. Multi display unit 3. Silencer tape 4. Clip 5. Control finisher Rem ...

Preparation

...

Other materials:

Service Notice or Precautions for Manual Transaxle
CAUTION: • Never reuse CSC (Concentric Slave Cylinder). Because CSC slides back to the original position every time when removing transaxle assembly. At this timing, dust on the sliding parts may damage a seal of CSC and may cause clutch fluid leakage. Refer to CL-27, "Removal and Inst ...

Washer switch
Component Inspection 1.CHECK WASHER SWITCH 1. Turn ignition switch OFF. 2. Disconnect combination switch connector. 3. Check continuity between the combination switch terminals. A : Terminal 4 B : Terminal 6 C : Terminal 3 D : Terminal 1 Is the inspection result normal? YES >> IN ...

P1811 power supply circuit for 4wd control module
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...