Electric controlled coupling oil seal

Exploded View 1. Rear final drive assembly 2. Electric controlled coupling oil seal A. Oil seal lip : Vehicle front : Always replace after every disassembly. : Apply multi purpose grease : ...

Exploded View

1. Final drive mounting bracket 2. Washer 3. Rear final drive assembly : Vehicle front : N·m (kg-m, ft-lb) : Never reuse parts : Apply multi purpose grease : Apply gear oil. ...

Other materials:

Engine oil
Inspection OIL LEVEL AND MUDDINESS • Before starting the engine, check the oil level placing vehicle horizontally. If the engine is already started, stop it and allow 10 minutes before checking. • Make sure the oil level is within the range shown in the figure. • If it is out of range, adj ...

P0703 brake switch B
Description BCM detects ON/OFF state of the stop lamp switch and transmits the data to the CVT control unit via CAN communication by converting the data to a signal. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CON ...

P1808 Wheel speed sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...