Nissan Leaf 2018-2025 (ZE1) Owner's Manual : Emergency call (SOS) button

In-vehicle Emergency Call SOS button located on the overhead console of the Nissan Leaf

The in-vehicle Emergency Call (SOS) system button integrates seamlessly with an active NissanConnect Services powered by SiriusXM subscription, providing drivers with an immediate lifeline to request critical roadside or emergency assistance whenever unexpected situations arise on the road.

By pressing this overhead button, your vehicle establishes a direct line (provided you have an active paid subscription) to a dedicated Response Specialist who can dispatch emergency services or provide real-time support based on the specific situation reported by your Nissan Leaf's occupants.

Charge port lid switch

Location of the charge port lid release switch on the lower dashboard of the Nissan Leaf

When you need to plug in your electric vehicle, simply press the dedicated charge port lid switch located on the lower dashboard panel to immediately unlock and open the exterior charging door of your Nissan Leaf.

Immediate Charge switch

Immediate Charge override switch next to the steering column

To bypass any pre-programmed charging schedules and instantly begin drawing power when connected to a station, pressing the immediate charge switch temporarily overrides the active charge timer on your Nissan Leaf.

    Heated steering wheel switch
    The Nissan Leaf heated steering wheel system is designed with intelligent efficiency, operating only when the surface temperature of the steering wheel is below approximately 68В ...

    Dynamic driver assistance switch (for vehicles without ProPILOT Assist)
    The physical dynamic driver assistance switch allows the operator to temporarily activate or deactivate the advanced Intelligent Lane Intervention (I-LI) and Intelligent Blind Sp ...

    Other materials:

    Diagnosis system (BCM)
    Common item COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the ...

    EPS branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the EPS control unit for damage, bend and loose connection (unit side and connector side). Is the inspection result no ...

    Power supply and ground circuit
    A/C auto AMP. : Diagnosis Procedure 1.CHECK SYMPTOM Check symptom (A or B). Which symptom is detected? A >> GO TO 2. B >> GO TO 5. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. Check 10A fuse (No. 3). NOTE: Refer to PG-23, "Fuse and Fusible Link Arrangement". ...