Nissan Juke Service and Repair Manual : P062B ECM

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Erase DTC.

3. Turn ignition switch OFF and wait for 20 seconds.

4. Turn ignition switch ON and perform the self-diagnosis.

Is the DTC P062B displayed again? YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE ECM

1. Replace ECM.

2. Go to EC-879, "Work Procedure".

>> INSPECTION END

    P061A ECM
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.INSPECTION START 1. Turn ignition switch ON. 2. Erase DTC. 3. Turn ignition switch OFF and wait for 20 seconds. 4. Turn ignition switch ON ...

    P0638 electric throttle control actuator function
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0638 is displayed with DTC P0120 or P2100, first perform trouble diagnosis for DTC P0120 or P2100. Refer to EC-909, "DTC Logic" (P0120), ...

    Other materials:

    Vehicle loading information
    WARNING It is extremely dangerous to ride in the cargo area inside the vehicle. In the event of a collision, individuals positioned in these unsecured areas are significantly more likely to suffer serious injury or fatalities. Never allow passengers to ...

    Rear suspension beam
    Exploded View 1. Rear suspension beam 2. Rear suspension arm bracket : Always replace after every disassembly. : N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Remove tires. Refer to WT-7, "Removal and Installation". 2. Drain brake fluid. Refer to BR-12, "Draining ...

    Additional service when replacing ECM
    Description When replacing ECM, this procedure must be performed. Work Procedure 1.PERFORM INITIALIZATION OF NATS SYSTEM AND REGISTRATION OF ALL NATS IGNITION KEY IDS Refer to SEC-50, "BCM : Special Repair Requirement" (With intelligent key system), SEC-190, "BCM : Work Proce ...