Reservoir tank cap

Inspection • Check valve seat of reservoir tank cap. - Check if valve seat (A) is swollen to the extent that the edge of the metal plunger (B) cannot be seen when watching it vertically from t ...

Radiator

Exploded View 1. Reservoir tank cap 2. Reservoir tank 3. Clamp 4. Reservoir tank hose 5. Mounting rubber (upper) 6. Reservoir tank hose 7. Radiator 8. Mounting rubber (lower) 9. Drain ...

Other materials:

Unlock sensor
Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “UNLK SEN -DR” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >&g ...

Liquid Gasket
REMOVAL OF LIQUID GASKET SEALING • After removing mounting nuts and bolts, separate the mating surface using the seal cutter [SST: KV10111100] (A) and remove old liquid gasket sealing. CAUTION: Be careful not to damage the mating surfaces. • Tap the seal cutter [SST: KV10111100] to inser ...

High-mounted stop lamp
Exploded View 1. High-mounted stop lamp 2. Seal packing : N·m (kg-m, in-lb) Removal and Installation CAUTION: Disconnect battery negative terminal or remove the fuse. REMOVAL 1. Remove blind seal from back door inside. CAUTION: Be careful not to damage the blind seal, so that it can ...