Nissan Juke Service and Repair Manual : Removal and installation

Radiator : Inspection
Check radiator for mud or clogging. If necessary, clean radiator as follows. CAUTION: Be careful not to bend or damage radiator fins. When radiator is cleaned without removal, remove all surr ...

Radiator
Exploded View 1. Cooling fan assembly 2. Mounting rubber (upper) 3. Radiator 4. Mounting rubber (lower) 5. O-ring 6. Drain plug 7. Clamp 8. Radiator hose (lower) (LH) 9. Reservoir tank h ...

Other materials:

4WD warning lamp does not turn on
Description 4WD warning lamp does not turn ON when the ignition switch is turned to ON. Diagnosis Procedure 1.CHECK 4WD WARNING LAMP Perform the trouble diagnosis for 4WD warning lamp. Refer to DLN-80, "Diagnosis Procedure". Is the inspection result normal? YES >> Check eac ...

Assembly and Installation
Use torque wrench to tighten bolts or nuts to specification. When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, then ones on inside and outside diagonally in this order. If the order of tightening is specified, do ...

C1601 battery power supply
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC CONFIRMATION PROCEDURE has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...