Refilling

1. Remove filler plug (1). Fill with new gear oil until oil level reaches the specified level near filler plug mounting hole Oil grade and viscosity : Refer to MA-13, "Fluids and Lubricants&qu ...

Front oil seal

Exploded View 1. Rear final drive assembly 2. Front oil seal 3. Companion flange 4. Companion flange lock nut A. Oil seal lip : Vehicle front : N·m (kg-m, ft-lb) : Never reuse parts : App ...

Other materials:

Compressor dose dot operate
Description SYMPTOM Compressor dose not operate. Diagnosis Procedure NOTE: • Perform self-diagnosis with CONSULT-III before performing symptom diagnosis. If any malfunction result or DTC is detected, perform the corresponding diagnosis. • Check that refrigerant is enclosed in cooler cycle n ...

Combination switch output circuit
Diagnosis Procedure 1.CHECK OUTPUT 1 - 5 CIRCUIT FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect BCM and combination switch connectors. 3. Check continuity between BCM harness connector and combination switch harness connector Does continuity exist? YES >> GO TO 2. NO >> ...

Blower motor
Diagnosis Procedure 1.CHECK SYMPTOM Check symptom (A or B). Which symptom is detected? A >> GO TO 2. B >> GO TO 7. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. Check 15A fuses (Nos. 14 and 16, located in fuse block (J/B)]. NOTE: Refer to PG-22, "Fuse, Connector and ...