Nissan Juke Service and Repair Manual : Refilling
1. Remove filler plug (1). Fill with new gear oil until oil level reaches the specified level near filler plug mounting hole
Oil grade and viscosity : Refer to MA-13, "Fluids and Lubricants".
Oil capacity : Refer to DLN-167, "General Specification".
2. After refilling oil, check oil level. Set a new gasket to filler plug, then install it to final drive assembly. Refer to DLN-151, "Exploded View".
CAUTION:
Never reuse gasket.
Draining
1. Stop engine.
2. Remove drain plug (1) and drain gear oil.
3. Set a new gasket on drain plug and install it to final drive assembly
and tighten to the specified torque. Refer to DLN-151,
"E ...
Other materials:
P0605 ECM
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...
B2581, B2582 intake sensor
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC is displayed along with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to HAC-
141, "DTC Logic".
• If DTC is displayed along with DTC U1010, first perform the trouble diagnosis
for DTC U1010. HAC-142,
"DTC ...
Owner’s Manual Supplement 2014 Nissan Juke
The information contained within this supplement replaces the Sun Visors information
contained in Section 3 “Pre-driving checks and adjustments”, the Manual Air Conditioner
(if so equipped) and Automatic Air Conditioner (with Integrated Control System)
information in Section 4 “Heater, a ...
