Nissan Juke Service and Repair Manual : Draining
1. Stop engine.
2. Remove drain plug (1) and drain gear oil.
3. Set a new gasket on drain plug and install it to final drive assembly and tighten to the specified torque. Refer to DLN-151, "Exploded View".
CAUTION:
Never reuse gasket.
Inspection
OIL LEAKAGE
Check rear final drive surrounding area (oil seal, drain plug, filler plug,
and carrier case, etc.) for oil leakage.
OIL LEVEL
1. Remove filler plug (1) and check oil level from fil ...
Refilling
1. Remove filler plug (1). Fill with new gear oil until oil level reaches
the specified level near filler plug mounting hole
Oil grade and viscosity : Refer to MA-13, "Fluids
and Lubricants&qu ...
Other materials:
Map lamp
Exploded View
1. Map lamp bulb housing
2. Bulb
3. Lens
: Pawl
Removal and Installation
CAUTION:
Disconnect the battery negative terminal or the fuse.
REMOVAL
1. Remove the lens (1).
• Insert a remover tool (A) into the gap between the lens.
• Disengage the lens fixing pawls, and t ...
Headlamp washer system
Wiring Diagram - HEADLAMP WASHER SYSTEM -
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation
of Option Abbreviation".
...
Rear washer nozzle and tube
Hydraulic Layout
1. Rear washer nozzle
2. Plug
3. Rear washer tube
4. Joint
5. Second washer tube
6. Back door seal rubber
7. Front washer tube
: Clip
: Pawl
Removal and Installation
REMOVAL
1. Remove luggage side upper finisher RH. Refer to INT-32, "LUGGAGE SIDE
UPPER FINIS ...
