Symptom diagnosis

NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applic ...

Inspection

OIL LEAKAGE Check rear final drive surrounding area (oil seal, drain plug, filler plug, and carrier case, etc.) for oil leakage. OIL LEVEL 1. Remove filler plug (1) and check oil level from fil ...

Other materials:

Test Value and Test Limit
The following is the information specified in Service $06 of ISO 15031-5. The test value is a parameter used to determine whether a system/circuit diagnostic test is OK or NG while being monitored by the ECM during self-diagnosis. The test limit is a reference value which is specified as the ...

Rear wiper arm
Exploded View 1. Rear wiper motor 2. Rear wiper blade 3. Rear wiper arm 4. Rear wiper arm cover 5. Rear wiper pivot seal A : Model for cold areas : Pawl : N·m (kg-m, in-lb) : N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Operate rear wiper to the auto stop position. 2. Remo ...

A/C switch
Component Function Check 1.CHECK A/C ON SIGNAL With CONSULT-III 1. Turn ignition switch ON. 2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III. 3. Select “AIR COND SW” in “DATA MONITOR” mode, and check status under the following condition. Is the inspection result normal? YES >> ...