Flushing

1. Install reservoir tank if removed and radiator drain plug. CAUTION: Be sure to clean drain plug and install with new O-ring. Radiator drain plug : Refer to CO-42, "Exploded View". • ...

Radiator cap : Inspection

Check valve seat (A) of radiator cap. B : Metal plunger - Check that valve seat is swollen to the extent that the edge of the plunger cannot be seen when watching it vertically from the top. - Che ...

Other materials:

Periodic maintenance
REAR PROPELLER SHAFT Inspection APPEARANCE AND NOISE • Check the propeller shaft tube surface for dents or cracks. If damaged, replace propeller shaft assembly. • If center bearing is noisy or damaged, replace propeller shaft assembly. VIBRATION If vibration is present at high speed, inspe ...

PTC branch line circuit
Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the PTC heater control unit for damage, bend and loose connection (unit side and connector side). Is the inspection re ...

Unlock sensor
Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “LOCK STATUS” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Unlock sensor is OK. ...