Symptom diagnosis

OVERHEATING CAUSE ANALYSIS Troubleshooting Chart ...

Inspection

LEVEL • Check that the reservoir tank engine coolant level is within the “MIN” to “MAX” when the engine is cool. A : MAX B : MIN • Adjust the engine coolant level if necessary. LEAKAGE • To c ...

Other materials:

Driver air bag module
Exploded View 1. Steering column upper cover 2. Steering column assembly 3. Steering column lower cover 4. Side lid LH 5. TORX bolt 6. Driver air bag module 7. TORX bolt 8. Side lid RH 9. Steering wheel 10. Spiral cable 11. Steering angle sensor 12. Combination switch 13. Stee ...

P0607 ECM
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC. Is DTC detected? YES >> Proceed to EC-685, "Diagnosis Procedure". NO >> INSPECTION END Diagnosis Procedure 1.INSPECTION START ...

Push-button ignition switch position indicator does not illuminate
Description • Before performing the diagnosis in the following table, check “Work Flow”. Refer to PCS-88, "Work Flow". • Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom. Conditions of Vehicle (Operating ...