Nissan Juke Service and Repair Manual : Inspection

LEVEL

• Check that the reservoir tank engine coolant level is within the “MIN” to “MAX” when the engine is cool.

A : MAX
B : MIN

• Adjust the engine coolant level if necessary.

LEAKAGE


LEAKAGE

• To check for leakage, apply pressure to the cooling system with the radiator cap tester (commercial service tool) (A) and the radiator cap tester adapter (commercial service tool) (B).

Testing pressure: Refer to CO-29, "Radiator".

WARNING:
Never remove radiator cap when engine is hot. Serious burns may occur from high-pressure engine coolant escaping from radiator.

CAUTION:
Higher test pressure than specified may cause radiator damage.

NOTE:

In a case that engine coolant decreases, replenish radiator with engine coolant.

• If anything is found, repair or replace damaged parts.

Draining


    Periodic maintenance
    ENGINE COOLANT ...

    Draining
    WARNING: • Never remove radiator cap when engine is hot. Serious burns may occur from high-pressure engine coolant escaping from radiator. • Wrap a thick cloth around the radiator cap. Slowly tur ...

    Other materials:

    Vehicle speed sensing auto lock operation does not operate
    Diagnosis Procedure 1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT” mode. 3. Check “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT”. Refer to DLK-217, "DOOR LOCK ...

    How to read the displayed lines
    Guiding lines which indicate the vehicle width and distances to objects with reference to the bumper lineA are displayed on the monitor. Distance guide lines: Indicate distances from the bumper. • Red line1 : approx. 1.5 ft (0.5 m) • Yellow line2 : approx. 3 ft (1 m) • Green line3 : approx. ...

    Engine idle speed too high
    Description CHART 5: ENGINE IDLE SPEED TOO HIGH Diagnosis Procedure 1.CHECK ECM POWER SUPPLY AND GROUND CIRCUIT Check ECM power supply and ground circuit. Refer to EC-885, "Diagnosis Procedure". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or repla ...