Precautions

Liquid Gasket REMOVAL OF LIQUID GASKET SEALING • After removing mounting nuts and bolts, separate the mating surface using the seal cutter [SST: KV10111100 (J-37228)] (A) and remove old liquid g ...

Engine oil

Inspection ENGINE OIL LEVEL NOTE: Before starting engine, put vehicle horizontally and check the engine oil level. If engine is already started, stop it and allow 10 minutes before checking. ...

Other materials:

C1121, C1123, C1125, C1127 ABS out valve system
DTC Logic DTC DETECTION LOGIC wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT-III 1. Turn the ignition switch OFF to ON. 2. Perform self-diagnosis for “ABS”. Is DTC “C1121”, “C1123”, “C1125” or “C1127” ...

Primary speed sensor
Exploded View 1. Transaxle assembly 2. O-ring 3. Primary speed sensor : Always replace after every disassembly. : N m (kg-m, in-lb) : Genuine NISSAN CVT Fluid NS-2 Removal and Installation REMOVAL 1. Remove the battery. Refer to PG-124, "Removal and Installation". 2. Remove ...

Throttle valve closed position learning
Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time harness connector of electric throttle control actuator or ECM is disconne ...