Nissan Juke Service and Repair Manual : Mixture ratio self-learning value clear

Description

This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure”.

Work Procedure

1. Start engine and warm it up to normal operating temperature.With CONSULT-III


1. Start engine and warm it up to normal operating temperature.

2. Select “SELF-LEARNING CONT” in “WORK SUPPORT” mode of “ENGINE” using CONSULT-III.

3. Clear mixture ratio self-learning value by touching “CLEAR”.

1. Start engine and warm it up to normal operating temperature. With GST


1. Start engine and warm it up to normal operating temperature.

2. Turn ignition switch OFF.

3. Disconnect mass air flow sensor harness connector.

4. Restart engine and let it idle for at least 5 seconds.

5. Stop engine and reconnect mass air flow sensor harness connector.

6. Select Service $03 with GST. Make sure DTC P0102 is detected.

7. Select Service $04 with GST to erase the DTC P0102.

>> END

    G sensor calibration
    Description ECM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the following wo ...

    Fuel pressure
    Work Procedure FUEL PRESSURE RELEASE With CONSULT-III 1. Turn ignition switch ON. 2. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINE” using CONSULT-III. 3. Start ...

    Other materials:

    Evap canister
    2WD : Hydraulic Layout EVAPORATIVE EMISSION LINE DRAWING 1.EVAP canister purge volume control solenoid valve 2. EVAP canister 3. EAVP line 4. Fuel line NOTE: Do not use soapy water or any type of solvent while installing vacuum hose or purge hoses. 2WD : Removal and Installation REMOV ...

    ECU diagnosis information
    4WD control module Reference Value VALUES ON THE DIAGNOSIS TOOL TERMINAL LAYOUT PHYSICAL VALUES *: The values are changed by throttle opening and engine speed. CAUTION: When using circuit tester to measure voltage for inspection, be sure not to extend forcibly any connector t ...

    Meter buzzer circuit
    Component Function Check 1.CHECK OPERATION OF METER BUZZER 1. Select “BUZZER” of “BCM” on CONSULT-III. 2. Perform “LIGHT WARN ALM” of “Active Test”. Does meter buzzer beep? YES >> INSPECTION END NO >> GO TO 2. 2.CHECK COMBINATION METER INPUT SIGNAL Select the ...