Nissan Juke Service and Repair Manual : G sensor calibration

Description

ECM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the following work is performed.

• Removal/installation or replacement of G sensor • Replacement of ECM

Work Procedure

1.PREPARATION BEFORE CALIBRATION PROCEDURE

1. Park the vehicle on a level surface.

2. Adjust air pressure of all tires to the specified pressure. WT-9, "Tire Air Pressure".

>> GO TO 2.

2.PERFORM CALIBRATION

1. Turn ignition switch ON. With CONSULT-III


1. Turn ignition switch ON.

CAUTION:
Never start engine.

2. Select “Work Support” mode in “ENGINE.

3. Select “G SENSOR CALIBRATION”.

4. Touch “Start”.

CAUTION:


Never swing the vehicle during “G sensor calibration

”.

Is “COMPLETED” displayed? YES >> END NO >> Perform steps 1 and 2 again.

    Idle air volume learning
    Description Idle Air Volume Learning is a function of ECM to learn the idle air volume that keeps each engine idle speed within the specific range. It must be performed under any of the following ...

    Mixture ratio self-learning value clear
    Description This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure”. Work Procedure With CONSULT-III 1. ...

    Other materials:

    Side oil seal
    Exploded View 1. Rear final drive assembly 2. Side oil seal (right) 3. Electric controlled coupling (right) 4. Reamer bolt 5. Side oil seal (left) 6. Electric controlled coupling (left) A. Oil seal lip B. Gear carrier mouting face : Vehicle front : N·m (kg-m, ft-lb) : Always replace ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconne
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...

    Headlamp (LO) circuit
    Component Function Check 1.CHECK HEADLAMP (LO) OPERATION CONSULT-III ACTIVE TEST 1. Select “EXTERNAL LAMPS” of IPDM E/R active test item. 2. With operating the test items, check that the headlamp (LO) is turned ON. Lo : Headlamp (LO) ON Off : Headlamp (LO) OFF Is the inspection result nor ...