Reference Value

VALUES ON THE DIAGNOSIS TOOL Remarks: • Specification data are reference values. • Specification data are output/input values which are detected or supplied by the ECM at the connector. * ...

DTC Inspection Priority Chart

If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart. NOTE: *: If “P1197” is displayed with other DTC in priority 1, perform tro ...

Other materials:

Front wheel hub and K
Exploded View 1. Steering knuckle 2. Splash guard 3. Hub bolt 4. Wheel hub assembly (Bearing-integrated type) 5. Disc rotor 6. Wheel hub lock nut 7. Adjusting cap 8. Cotter pin A. Tightening must be done following the installation procedure. Refer to FAX-68, "Removal and Insta ...

P183F gear position signal
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...

Rear door
Exploded View 1. Rear door panel 2. Door hinge (upper) 3. Door hinge (lower) 4. Door check link 5. Door striker 6. TORX bolt : Do not reuse : N·m (kg-m, in-lb) : N·m (kg-m, ft-lb) : Body grease DOOR ASSEMBLY DOOR ASSEMBLY : Removal and Installation CAUTION: • Perform work wit ...