Nissan Juke Service and Repair Manual : DTC Inspection Priority Chart

If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart.

NOTE:


NOTE

:
*: If “P1197” is displayed with other DTC in priority 1, perform trouble diagnosis for “P1197” first.

    Fail Safe
    NON DTC RELATED ITEM DTC RELATED ITEM ...

    DTC Index
    *1: 1st trip DTC No. is the same as DTC No. *2: This number is prescribed by SAE J1979/ ISO 15031-5. *3: In Diagnostic Test Mode II (Self-diagnostic results), this number is controlled b ...

    Other materials:

    P17B7 high clutch solenoid
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION 1. S ...

    Parts Requiring Angle Tightening
    • Use the angle wrench [SST: KV10112100 (BT8653-A)] for the final tightening of the following engine parts: - Camshaft sprocket (INT) bolt - Cylinder head bolts - Main bearing cap bolts - Connecting rod cap bolts - Crankshaft pulley bolt (No the angle wrench is required as bolt flange is ...

    Models with Intelligent Key system
    1. Apply the parking brake. 2. Move the shift lever to the P (Park) or N (Neutral) position. (P is recommended.) The starter is designed not to operate unless the shift lever is in either of the above positions. Manual Transmission (MT) models: Move the shift lever to the N (Neutral) position ...