Diagnosis system (ECM)

Diagnosis description Diagnosis description : 1st Trip Detection Logic and Two Trip Detection Logic When a malfunction is detected for the first time, 1st trip DTC and 1st trip Freeze Frame data ...

Reference Value

VALUES ON THE DIAGNOSIS TOOL Remarks: • Specification data are reference values. • Specification data are output/input values which are detected or supplied by the ECM at the connector. * Spec ...

Other materials:

Cylinder block
Exploded View 1. Crankshaft position sensor (POS) cover 2. Crankshaft position sensor (POS) 3. O-ring 4. Drain plug 5. Cylinder block 6. Oil level gauge 7. Oil level gauge guide 8. O-ring 9. Knock sensor 10. Oil temperature sensor 11. Oil pressure sensor 12. Oil jet 13. Top rin ...

P0720 output speed sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repair, p ...

Changing wheels and tires
Tire rotation NISSAN recommends rotating the tires every 5,000 miles (8,000 km). (See “Flat tire”  for tire replacing procedures.) As soon as possible, tighten the wheel nuts to the specified torque with a torque wrench. Wheel nut tightening torque: 80 ft-lb (108 N·m) The wheel nuts ...