Check anti-pinch function

Description If any of the following operations are performed, the initialization is necessary for normal operation of antipinch function. • Disconnection and connection of battery cable from ne ...

Power supply and ground circuit

Power window main switch POWER WINDOW MAIN SWITCH : Diagnosis Procedure 1.CHECK POWER WINDOW MAIN SWITCH POWER SUPPLY 1. Turn ignition OFF. 2. Disconnect power window main switch connector. 3. Ch ...

Other materials:

P0045, P0047, P0048 TC boost control solenoid valve
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

Precaution Necessary for Steering Wheel Rotation after Battery Disconne
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

B1080, B1096 driver air bag module
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...