Nissan Juke Service and Repair Manual : Check anti-pinch function

Description

If any of the following operations are performed, the initialization is necessary for normal operation of antipinch function.

• Disconnection and connection of battery cable from negative terminal.

• When power window main switch replaced.

• Electric power supply to power window main switch or power window motor (driver side) is interrupted by blown fuse or disconnection and connection of the negative terminal of battery, etc.

• Disconnection and connection of power window main switch harness connector.

• Removal of power window motor (driver side) from regulator assembly.

• Operation of regulator assembly as an independent unit.

• Removal and installation of glass.

• Removal and installation of door glass run.

Work Procedure

1.CHECK ANTI-PINCH FUNCTION

1. Fully open the door window.

2. Place a piece of wood near fully closed position.

3. Close door glass completely with AUTO-UP.

4. Check the following conditions.

- Check that glass lowers for approximately 150 mm (5.9 in) without pinching piece of wood and stops.

- Check that glass does not rise not when operating the power window main switch while lowering.

CAUTION:
• Perform initial setting when AUTO-UP operation or anti-pinch function does not operate normally.

• Check that AUTO-UP operates before inspection when system initialization is performed.

• Do not check with hands and other body parts because they may be pinched. Do not get pinched.

>> END

    System initialization
    Description If any of the following operations are performed, the initialization is necessary for normal operation of power window system. • Disconnection and connection of battery cable from ...

    Other materials:

    Hazard and buzzer reminder does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index&qu ...

    Doors
    WARNING •  Always have the doors locked while driving. Along with the use of seat belts, this provides greater safety in the event of an accident by helping to prevent persons from being thrown from the vehicle. This also helps keep children and others from unintentionally opening the ...

    P2120 APP sensor
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or ...