Nissan Juke Service and Repair Manual : System initialization

Description

If any of the following operations are performed, the initialization is necessary for normal operation of power window system.

• Disconnection and connection of battery cable from negative terminal.

• When power window main switch replaced.

• Electric power supply to power window main switch or power window motor (driver side) is interrupted by blown fuse or disconnection and connection of the negative terminal of battery, etc.

• Disconnection and connection of power window main switch harness connector.

• Removal of power window motor (driver side) from regulator assembly.

• Operation of regulator assembly as an independent unit.

• Removal and installation of glass.

• Removal and installation of door glass run.

CAUTION:
The following specified operations can not be performed under the non-initialized condition.

• Auto-up operation
• Anti-pinch function

Work Procedure

1.STEP 1

1. Turn ignition switch ON.

2. Operate power window switch to fully open the window. (This operation is unnecessary if the window is already fully open)
3. Continue pulling the power window switch UP (AUTO-UP operation). Even after glass stops at fully closed position, keep pulling the switch for 2 seconds or more.

4. Check that AUTO-UP function operates normally.

>> GO TO 2.

2.STEP 2

Check anti-pinch function. Refer to PWC-17, "Work Procedure".

>> END

    Additional service when replacing control unit
    Description When the control unit replaced, the initialization in necessary for normal operation of power window system. CAUTION: The following specified operations can not be performed under t ...

    Check anti-pinch function
    Description If any of the following operations are performed, the initialization is necessary for normal operation of antipinch function. • Disconnection and connection of battery cable from ...

    Other materials:

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...

    Sun visors
    1. To effectively block blinding sunlight or glare originating from directly ahead, simply swing down 1 the primary sun visor assembly toward the windshield. 2. To block harsh rays penetrating from the side glass, unclip the main sun visor from its central plasti ...

    Refilling
    1. Remove filler plug (1) and gasket. Then fill oil up to mounting hole for the filler plug. : Vehicle front Oil and viscosity : Refer to MA-13, "Fluids and Lubricants". Oil capacity : Refer to DLN-117, "General Specifications". CAUTION: Carefully fill the oil. (Fill up ...