Nissan Juke Service and Repair Manual : Basic inspection
COLLISION DIAGNOSIS
- For frontal collision : When SRS is activated in a collision
- For frontal collision : When SRS is not activated in a collision
- For side and rollover collision : When SRS is activated in a collision
- For side and rollover collision : When SRS is not activated in a collision
Preparation
Special Service Tool
Commercial Service Tools
...
For frontal collision : When SRS is activated in a collision
CAUTION:
Due to varying models and option levels, not all parts listed in the chart below
apply to all vehicles.
WORK PROCEDURE
1. Before performing any of the following steps, ensure that all ...
Other materials:
Parking brake switch signal circuit
Diagnosis Procedure
1.CHECK COMBINATION METER INPUT SIGNAL
1. Turn ignition switch ON.
2. Check the voltage between combination meter harness connector and ground.
Is the inspection result normal?
YES >> INSPECTION END
NO >> GO TO 2.
2.CHECK PARKING BRAKE SWITCH SIGNAL CIRCUIT ...
Vehicle Dynamic Control (VDC) system
The Vehicle Dynamic Control (VDC) system uses various sensors to monitor driver
inputs and vehicle motion. Under certain driving conditions, the VDC system helps
to perform the following functions.
• Controls brake pressure to reduce wheel slip on one slipping drive wheel so
power is transfer ...
B1134 side air bag module LH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
