Service

• Never use electrical test equipment to check SRS circuits unless instructed to in this Service Manual. • Before servicing the SRS, turn ignition switch OFF, disconnect battery negative terminal ...

Basic inspection

COLLISION DIAGNOSIS ...

Other materials:

Unit disassembly and assembly
Torque converter and converter housing oil seal Exploded View 1. Transaxle assembly 2. Converter housing oil seal 3. Torque converter : Always replace after every disassembly. : Apply CVT Fluid NS-2. Disassembly 1. Remove transaxle assembly. Refer to TM-301, "Removal and Installat ...

P1205 exhaust fuel injector
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK EXHAUST FUEL INJECTOR POWER SUPPLY CIRCUIT FOR OPEN AND SHORT 1. Turn ignition switch OFF. 2. Disconnect exhaust fuel injector harness connector. 3. Turn ignition switch ON. 4. Check the voltage between exhaust fuel injector harness ...

4WD warning lamp blinks slowly
Description 4WD warning lamp blinks at approximately 2 seconds intervals while driving. Diagnosis Procedure 1.CHECK TIRE Check the following. • Tire pressure • Wear condition • Front and rear tire size (There is no difference between front and rear tires.) Is the inspection result normal ...