Nissan Juke Service and Repair Manual : Malfunction indicator lamp

Component Function Check

1.CHECK MIL FUNCTION

1. Turn ignition switch ON.

2. Check that MIL lights up.

Is the inspection result normal? YES >> INSPECTION END NO >> Proceed to EC-436, "Diagnosis Procedure".

Diagnosis Procedure INFOID:0000000006547250 1.CHECK DTC

Check that DTC UXXXX is not displayed.

Is the inspection result normal? YES >> GO TO 2.

NO >> Perform trouble diagnosis for DTC UXXXX.

2.CHECK DTC WITH METER

Refer to MWI-23, "CONSULT-III Function".

Is the inspection result normal? YES >> GO TO 3.

NO >> Perform trouble diagnosis for DTC indicated.

3.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation".

NO >> Repair or replace error-detected parts.

    Information display (speed limiter)
    Component Function Check 1.CHECK INFORMATION DISPLAY (SPEED LIMITER) FUNCTION 1. Start engine. 2. Press speed limiter MAIN switch. 3. Drive the vehicle at more than 30 km/h (20 MPH). CAUTION: ...

    Other materials:

    4WD warning lamp does not turn on
    Description 4WD warning lamp does not turn ON when the ignition switch is turned to ON. Diagnosis Procedure 1.CHECK 4WD WARNING LAMP Perform the trouble diagnosis for 4WD warning lamp. Refer to DLN-80, "Diagnosis Procedure". Is the inspection result normal? YES >> Check eac ...

    C1111 ABS motor, motor relay system
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE� has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CON ...

    P1550 battery current sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. ...