Nissan Juke Service and Repair Manual : Information display (speed limiter)

Component Function Check

1.CHECK INFORMATION DISPLAY (SPEED LIMITER) FUNCTION

1. Start engine.

2. Press speed limiter MAIN switch.

3. Drive the vehicle at more than 30 km/h (20 MPH).

CAUTION:
Always drive vehicle at a safe speed.

4. Press SET/− switch.

5. Perform a test drive on a flat road conditions. Check that the speedometer indicated the same value as the set speed indicator on the information display while depressing the accelerator pedal until just before a kickdown occurs.

Is the inspection result normal? YES >> INSPECTION END

NO >> Proceed to EC-435, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC

Check that DTC UXXXX, P0500 or P1574 is not displayed.

Is the inspection result normal? YES >> GO TO 2.

NO-1 >> Perform trouble diagnosis for DTC UXXXX.

NO-2 >> Perform trouble diagnosis for DTC P0500. Refer to EC-286, "DTC Logic".

NO-3 >> Perform trouble diagnosis for DTC P1574. Refer to EC-352, "DTC Logic".

2.CHECK DTC WITH COMBINATION METER

Refer to MWI-23, "CONSULT-III Function".

Is the inspection result normal? YES >> GO TO 3.

NO >> Perform trouble diagnosis for DTC indicated.

3.CHECK INTERMITTENT INCIDENT

Perform GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation".

NO >> Repair or replace error-detected parts.

    Information display (ASCD)
    Component Function Check 1.CHECK INFORMATION DISPLAY 1. Start engine. 2. Press ASCD MAIN switch on ASCD steering switch. 3. Drive the vehicle at more than 40 km/h (25 MPH). CAUTION: Always dri ...

    Malfunction indicator lamp
    Component Function Check 1.CHECK MIL FUNCTION 1. Turn ignition switch ON. 2. Check that MIL lights up. Is the inspection result normal? YES >> INSPECTION END NO >> Proceed to EC-43 ...

    Other materials:

    Cylinder head
    Exploded View REMOVAL 1. Cylinder head assembly 2. Cylinder head bolt 3. Cylinder head gasket A. Tightening must be done following the installation procedure. Refer to EM-91 : N·m (kg-m, ft-lb) : Always replace after every disassembly. : Should be lubricated with oil. DISASSEMBLY ...

    EPS branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the EPS control unit for damage, bend and loose connection (unit side and connector side). Is the inspection result no ...

    Liquid Gasket
    REMOVAL OF LIQUID GASKET SEALING • After removing mounting nuts and bolts, separate the mating surface using the seal cutter [SST: KV10111100 (J-37228)] (A) and remove old liquid gasket sealing. CAUTION: Be careful not to damage the mating surfaces. • Tap the seal cutter [SST: KV10111100 ...