Malfunction indicator lamp

Component Function Check 1.CHECK MIL FUNCTION 1. Turn ignition switch ON. 2. Check that MIL lights up. Is the inspection result normal? YES >> INSPECTION END NO >> Proceed to EC-43 ...

Engine control system

Symptom Table SYSTEM — BASIC ENGINE CONTROL SYSTEM 1 - 6: The numbers refer to the order of inspection. (continued on next page) SYSTEM — ENGINE MECHANICAL & OTHER 1 - 6: The nu ...

Other materials:

P position warning does not operate
Diagnosis Procedure 1.CHECK DTC WITH BCM, TCM AND COMBINATION METER Check that DTC is not detected with BCM, TCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to TM-171, "DT ...

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is include ...

P0710 transmission fluid temperature sensor A
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repair, p ...